A screwdriver is a necessary and useful device in every home. After all, you often have to screw or unscrew the screws and screws. But there are many other ways to use this tool, sometimes very unusual.
These methods have become available thanks to the design of the screwdriver. The cam cartridge allows you to clamp metal rods of different sections. The rotation speed can be adjusted, and it is not as high as, for example, in a grinder or drill. This allows you to insert into the tool, and it is safe to use many nozzles that would seem far from the traditional applications of a screwdriver.
Kitchen mixer
Everything is simple here. You need to take a whisk, insert it into the cartridge, hold it in the most durable way and use it. But you should pay attention to the details. In particular, nozzles for an electric mixer can have special blades on the rod to snap and hold onto the original tool. In a screwdriver, they will interfere with the mount. If such blades are located high, the nozzle itself will stick out very strongly from the screwdriver, and the fastening may be insufficient.
Never attempt to adjust the fork or other cutlery. In manual corollas, the pin is round, easily inserted and held by a screwdriver chuck. But the flat end of the cutlery can fly out when untwisted. The number of revolutions, although less than in other tools, will be quite sufficient to cause serious injuries.
Electric meat grinder
In this case, the same principle of clamping the end of the working tool in the chuck of a screwdriver applies. This is a spiral knife, on which a handle is usually worn. Instead, the role of the twisting device will be performed by our tool.
In this embodiment, the feature is that the edge of the spiral is very thick, with one flat side. And only a short section protruding from the meat grinder can be inserted into the cartridge. Therefore, before starting work, check the strength of the mount. Scroll at the lowest possible speed. Never push meat or other products with your hand. You need to take a special device, preferably made of wood. A spoon, objects made of metal or plastic are also suitable. But they can damage the surface of the knife, or crumbs of plastic get into processed products.
Clean sink drain hole
In this case, the advantages will be a high degree of rotation of the nozzle, the ability to make a long pin that penetrates deep into the drain hole and will reach any rubbish.
You need to take a brush for washing dishes, increase the metal handle to the required height, insert into the cartridge. Then we insert the brush into the hole, turn on the device and drive up and down, trying to crush the garbage. The brush handle must be metal. Plastic in this case will not work, since it is very fragile, it can not withstand rotation.
With this use, it is imperative to monitor two things: the strength of the connection between the brush and the pin, and the verticality of movements. Any bending of the pin can lead to excessive tension of the metal on the handle, and it simply bursts. This is due to the fact that the brush is not designed for such actions, the metal there is thin and weak.
Many devices and mechanisms can be adapted to perform non-standard operations. But in the foreground should be common sense and concern for safety.
